Figure Elevation Options

Raise, lower or flatten a selection set of figures.

Keyboard Command: FigElvOpt

• Flatten: Flattens the figure based on:
  • Average: Averages all existing figure elevations.
  • Minimum: Uses the minimum elevation found on the figure.
  • Maximum: Uses the maximum elevation found on the figure.
  • Value: Uses a specified value to apply to all elevations.
• Lower: Lowers the figure by a specified amount.
• Raise: Raises the figure by a specified amount.
• Surface: Sets the (flat) elevation of the figure based on surface elevations.
  • Average: Averages all surface definition points that lie inside the figure.
  • Centroid: Uses the always inside centroid to determine the elevation.
  • Vertices: Averages the elevation only at the points along the figure.