Figure Draw Traverse

Draw polylines by distances and numerous angle options. Useful for house perimeters, etc.

Keyboard Command: FigDrwTrv

The initial prompt is the starting point. Following that, you will see the arrow pointer and the following prompt:

DS> Angle/Close/Flip/Left/Right/North/South/East/West/Undo <Distance>:

• Distance: The default entry, the distance to travel in the direction the arrow is pointing.
• Angle: Enter or pick two points to set the arrow direction.
• Close: Closes the polyline and exits the routine.
• Flip: Flips the arrow direction 180°.
• Left: Turns the arrow 90° to the left.
• Right: Turns the arrow 90° to the right.
• North: Turns the arrow up (to the north).
• South: Turns the arrow down (to the south).
• East: Turns the arrow right (to the east).
• West: Turns the arrow left (to the west).
• Undo: Removes the last segment drawn.