Figure Point Report

Reports points (number, coordinates, distance, offset) along figures within tolerances.

Keyboard Command: FigPntRep

Procedure:

1. Open the drawing containing the figures and points.
2. Issue this command from the menu, ribbon or command above.
3. Select the figures to report (names are important, see note).
4. Select the points to consider for reporting.
5. Enter the minimum and maximum distances.
6. Designate whether to draw lines.

Notes:

• For Civil3D FeatureLines, the names should be entered. For all other geometry, Extended Entity Data should be added with a field for the name.
• If a point is less than the minimum distance from the figure, or greater than the maximum, it will not be reported.