These commands have short names (on purpose) and can be typed in at almost any time in the command area (while inside another command). All transparent commands need to be prefixed with the ' (single quote) character.
| Cmd | Category | Description |
|---|---|---|
| 'AC | Alternate Coord Entry | While in a drawing with a coordinate system assigned, you can enter 'AC then be prompted for the alternate coordinates. The default alternate system is Lat/Long (decimal). |
| 'LGP | Last GPS Point | Pumps the last GPS point received into the command prompt. For example start the insert command, at the point prompt enter 'LGP and press enter. |
| 'PP | Point Pump On/Off | Turns the hover point pump on/off. When you need to connect a series of system points begin the command (like PLINE) the enter 'PP to turn the point pump on. Simply move over the points as fast as practical and they will be pumped into the current command. At the command point afterwards you may need to repeat 'PP to turn it off. |
| 'PN2 | Point Coordinates 2D | Pumps the X,Y coordinates of a system point into the command prompt by specifying it's number (or name). |
| 'PN3 | Point Coordinates 3D | Pumps the X,Y and Z coordinates of a system point into the command prompt by specifying it's number (or name). |
| 'SO2 | Station/Offset Point 2D | Pumps the X,Y coordinates of an offset point into the command prompt by specifying it's station and offset. |
| 'SO3 | Station/Offset Point 3D | Pumps the X,Y and Z coordinates of an offset point into the command prompt by specifying it's station and offset. |
| 'UC | Units Conversion | Converts an entered value to an alternative units. |