Draw Parking Geometry

The tools below can be used to place new parking objects in the drawing.

Keyboard Command: DrwPrkGeo

• Double: Begins placement of double lined stalls (like three main instances above).
• Length: Sets the length of future stalls.
• Report: Generates a report of all selected parking objects. Sums of stalls and area reported at the bottom.
• Single: Begins placement of single lined stalls (like most instances above).
• Stripe: Sets the width of the stripe (polyline width).
• Width: Sets the width of future stalls.

Procedure:

1. Initiate the tool using the menu, ribbon or command above.
2. Optionally enter length and width for stalls to be created.
3. Enter S (for Single) or D (for Double) stalls to begin placement.
4. Pick two points to define the placement.

Notes:

• On Single placement the lines extend to the right, usually using endpoints. On Double placement the lines extend in both directions and usually use midpoint osnaps.