Polyline Continue

Continues an existing open lightweight or 3d polyline by picking near either end.

Keyboard Command: PlnDrwCon

Procedure:

1. Select the existing polyline near the end you wish to continue.
2. Continue drawing the polyline with the same options as the PLINE command provides.
3. Press enter to end the polyline.

Notes:

• 'The close option will not behave as expected. To close the polyline, complete the polyline, then use the PEDIT Close option or PROPS.
• If the picked end is curved, the proper tangent is used as if you were still in the polyline command with the arc mode on.
• If you press ESC (cancel) after drawing some segments, the program will ask if you want to keep the segments (as a new polyline).