The Erase command permits you to erase selected polylines.
Note: It will not erase points.
Options
-Selected polylines > [count]
Methods that can be used to select polylines include:
- Keying-in Last to select the last created polyline.
- Individual selection.
- Picking two opposing corners of a rectangle; any polylines that are inside or cross the rectangle sides are considered for erasure.
- Specifying the all option in the Cmd: prompt.
Note: There is no Undo so this would be permanent for the Job. However, you can redraw any linework created by Feature Codes using Tools - Field to Finish.
See also: